Janome 6019QC Instruction Book page 25

4
8
9
6
7
5
6 7
8
9
17
10
12
11
13
14
15
16
Draw the needle thread to the left through the hole
4
on the foot. Place the fabric under the foot and
lower the needle at the starting point of the
buttonhole mark. Then lower the foot.
6 Needle thread
Bobbin thread
7
Buttonhole mark
8
Starting point
9
NOTE: Make sure there is no gap between the slider
and spring holder, otherwise the left and right
length will be different.
10 Slider
Spring holder
11
12 No gap
Sewing gap
13
5 Depress the foot control to sew a buttonhole. Stop
the machine when the buttonhole is completed.
Raise the foot and cut the both needle and bobbin
6
threads leaving 10 cm (4") thread ends. Pull the
bobbin thread to draw the needle thread to the
wrong side of the fabric, and tie them together.
Remove the fabric and place a pin just before the
7
bartack at each end to prevent cutting bartacks.
Cut the opening with the seam ripper.
14 Pin
Seam ripper
15
To repeat buttonhole sewing:
Select the other pattern and re-select the
8
buttonhole by turning the pattern selector dial in
either " 1 " or " 2 " direction to reset for sewing the
next buttonhole.
16 Pattern selector dial
After the buttonhole sewing is finished, push the
9
buttonhole lever upward as far as it will go.
17 Buttonhole lever
23