Restore Using Ftp; Figure 6-13 Restore Example Using Hyperterminal; Figure 6-14 Successful Restoration Confirmation Screen; Figure 6-15 Menu 24.6 As Seen Using Telnet - ZyXEL Communications Prestige 642M series User Manual

Finally,
click Send.
After a successful restoration you will see the following screen. Press any key to return to reboot the
system.
Save to ROM
Hit any key to start system reboot.

Figure 6-14 Successful Restoration Confirmation Screen

6.6.2 Restore using FTP

Even though FTP should work over WAN as well, it is not recommended.
To transfer your current workstation configuration to your Prestige, follow the instructions as shown in the
following screen. See also the FTP example near the end of this chapter. For details on FTP commands,
please consult the documentation of your FTP client program.
To transfer the firmware and the configuration file, follow the procedure
below:
1. Launch the FTP client on your workstation.
1. Type "open" and the IP address of your system. Then type "root"
and SMT password as requested.
3. Type "put backupfilename rom-0" where "backupfilename" is the name of
your backup configuration file on your workstation and "rom-0" is the
remote file name on the system. This restores the configuration to
your system.
3. The system reboots automatically after a successful file transfer.
For details on FTP commands, please consult the documentation of your FTP
client program. For details on restoring using TFTP (note that you must
remain on this menu to restore using TFTP), please see your user manual.
System Maintenance

Figure 6-13 Restore Example Using HyperTerminal

Menu 24.6 – Restore Configuration
Press ENTER to Exit:

Figure 6-15 Menu 24.6 as seen using Telnet

Prestige 642M Series ADSL Bridge
Enter the location of the
rom configuration file on
your computer.
Choose the
Xmodem
Protocol.
6-11