Removing And Installing The Lamp Unit - Sharp Conference Series XG-PH80W-N Operation Manual

Removing and Installing the
Lamp Unit
Info
• Do not touch the glass surface of the lamp
unit or the inside of the projector.
• To avoid injury to yourself and damage to the
lamp, make sure you carefully follow the
steps below.
• Do not loosen other screws except for the
lamp unit cover and lamp unit.
1 1
Press STANDBY/ON on the
projector or on the remote
control to put the projector into
Standby mode.
2 2
Switch the MAIN POWER switch
on the projector to "OFF" and
then disconnect the power cord.
• Unplug the power cord from the AC
socket.
• Leave the lamp until it has fully cooled
down (about 1 hour).
3 3
Remove the lamp unit cover.
• Loosen the user service screw (1) that
secures the lamp unit cover. Remove the
lamp unit cover (2).
4 4
Remove the lamp unit.
• Loosen the securing screws (two for each
lamp) from the lamp unit. Hold the lamp
unit by the handle and pull it in the
direction of the arrow. At this time, keep
the lamp unit horizontal and do not tilt it.
Warning! Warning!
• • Do not remove the lamp unit from the Do not remove the lamp unit from the
projector right after use. The lamp and parts projector right after use. The lamp and parts
around the lamp will be very hot and may around the lamp will be very hot and may
cause burns or injury. cause burns or injury.
Optional Optional
accessory accessory
STANDBY/ON button STANDBY/ON button
MAIN POWER switch MAIN POWER switch
AC socket AC socket
User service screw User service screw
(for lamp unit cover) (for lamp unit cover)
Lamp unit Lamp unit
AN-PH80LP AN-PH80LP
67