Filter Message; Mode; Setting The Lan/Rs232C; Setting The Network - Sharp Conference Series XG-PH80W-N Operation Manual

Adjusting the Projector Function ("PRJ-ADJ" Menu)
(Continued)

Filter Message

You can select the interval time to display a
message for cleaning the fi lter.
Clean The Filter.
Selectable items
Off
100H/200H/
500H/1000H
3D MODE
You can set "DLP
Invert". See "Using 3D Viewing Mode" on
page 59 for details.

Setting the LAN/RS232C

You can select "LAN" or "RS232C" and
selected terminal is only used.
Selectable
items
LAN The LAN function is activated.
RS232C The RS-232C function is activated.

Setting the Network

■
Link
Selectable
items
Connected Connected to the network.
Disconnected Disconnected from the network.
■
DHCP Client
Connect the LAN cable before turning the
projector on. If not, the DHCP Client function
does not work. If the DHCP server is not
available, set the IP Address, Subnet Mask,
Gateway and DNS manually.
Selectable
items
On Obtains confi guration parameters for IP
Address, Subnet Mask, Gateway, and
DNS automatically.
Off Set the IP Address, Subnet Mask,
Gateway, and DNS manually.
54
Description
Not displaying the message.
Select the interval time to display
a message.
® TM ®
Link " and "DLP
Description
Description
Description
■
IP Address/Subnet Mask/Gateway/
DNS/Apply
Selectable
items
IP Address
Subnet
Mask
Gateway
TM
Link
DNS
Apply
Note
• Confi rm the existing network's segment (IP
address group) to avoid setting an IP address
that duplicates the IP addresses of other
network equipment or computers. If
"192.168.150.002" is not used in a network
with an IP address of "192.168.150.XXX", you
don't have to change the projector IP address.
• For details about each setting, consult your
network administrator.
Menu operation n Page
Description
Factory default setting:
192.168.150.002
Enter an IP address appropriate for the
network.
Factory default setting:
255.255.255.000
Set the subnet mask to the same as
that of the computer and equipment on
the network.
Factory default setting:
000. 000. 000. 000
* When not in use, set to "000. 000.
000. 000".
Factory default setting:
000. 000. 000. 000
* When not in use, set to "000. 000.
000. 000".
Apply and save the new settings.
41