Using 3D Viewing Mode
Use the following procedure to project
3D images.
For operation of the 3D LCD shutter
glasses and the 3D-video playback
equipment, see the corresponding
operation manual.
Projecting 3D images
1
1
Turn the projector on.
2
2
Turn the 3D-video playback
equipment on.
•
Set the 3D-video playback equipment so
that it outputs one of the signals listed in
the Compatibility Chart in this operation
manual.
3
3
Switch the Input mode of the
projector to enable input of 3D
video signals.
4
4
Operate the 3D-video playback
equipment and play back the 3D
content.
5
5
Turn the 3D LCD shutter glasses
on and place them over your eyes.
6
6
Press 3D MODE on the remote
control to display the 3D MODE
menu.
P/R buttons
(ENTER) button
3D MODE button
7
7
Press P or R to select "DLP
Link™", and then select "On".
8
8
®
Select "DLP
then press
the mode and enable more
natural 3D image viewing.
Warning!
•
If the projector, 3D-video playback
equipment, and 3D LCD shutter
glasses are not properly set, you may
experience eye strain in addition to not
being able to view the images in 3D.
9
9
Press 3D MODE.
•
The 3D MODE menu will disappear.
Note
•
If the images are not displayed in 3D, repeat
steps 6 to 8.
•
You can also use "DLP
Link™ Invert" on the menu screen to change
the 3D setting.
Ending 3D projection
1
1
Press 3D MODE on the remote
control to display the 3D MODE
menu.
2
2
Press P or R to select "DLP
Link™", and then select "Off".
3
3
Press 3D MODE.
•
The 3D MODE menu will disappear.
Note
•
You may not be able to enjoy the full 3D
effects depending on the installation or usage
environment of the projector.
•
When you use the 3D projection function, it is
recommended that "Lamp Mode" be set to "Both
Lamps" and "Eco + Quiet" be switched to "Off".
®
Link™ Invert", and
(ENTER) to switch
®
Link™" and "DLP
®
®
59