Sharp Conference Series XG-PH80W-N Operation Manual page 22

Easy Start (Continued)
5. Adjust the angle
Adjust the projector angle:
• Shift the lens horizontally and vertically.
- Press H&V LENS SHIFT (P/R/O/Q) on the projector.
- Press LENS SHIFT and then press P, R, O or Q on the remote
control.
• Adjust the projector angle by rotating the adjustment feet.
6. Adjust the focus and the zoom
1
Press FOCUS +/– on the projector or on the remote control to adjust the focus.
2
Press ZOOM +/– on the projector or on the remote control to adjust the zoom.
7. Correcting the image distortion due to the projection angle
1
Press MENU to display the menu screen.
2
Press O or Q to select "SCR-ADJ".
3
Press P or R to select "Keystone".
4
Press O or Q to adjust the Keystone Correction.
8. Select the Input mode
Press INPUT to display the INPUT list. Use P/R to select the Input mode.
INPUT list
INPUT
DVI-D
COMPUTER1
COMPUTER2
COMPONENT
9. Turn the computer on
10. Turn the power off
Press STANDBY/ON on the projector or on the remote control, and then press the button
again while the confi rmation message is displayed to put the projector into Standby mode.
On the projector
• You can unplug the power cord or switch the MAIN POWER switch to "OFF" even if the
projector is operating.
• Even if you unplug the power cord or switch the MAIN POWER switch to "OFF", the cooling
fan continues to run for a while.
18
On the projector
On the remote control
On the remote control
On-screen display
Enter STANDBY Mode?
Yes : Press Again
No : Please Wait
P. 30
P. 31
P. 32
P. 33
P. 28