Mitsubishi DX-PC200 Operation Manual page 44

【Ｅｓｔｉｍａｔｅｄ recording time】
In DX-TL5000 series recorders, you can check the estimated recording time on the recording setting
screen. Enter your desired recording settings and click the [View] button. The recording settings you
entered are sent to the recorder and the result of calculation of estimated recording time is displayed.
Note that the recording settings you entered are only sent to the recorder, not reflected in the
recorder. This function is unavailable when the recorder isn't connected.
You can inquire of the recorder the estimated recording time (week) using the timer setting screen.
Recorders not supporting this function may answer incorrectly. This function is available only while this
software is accessing the recorder.
【Motion detection】
Use the following methods to enable or disable the motion detection
dots.
DX-TL5000 series:
• Right-click to disable.
• Left-click to enable.
• Select a rectangular area by dragging the mouse holding down the
right button to disable the dots within the area.
• Select a rectangular area by dragging the mouse holding down the
left button to enable the dots within the area.
DX-TL2500 series:
• Left-click on each dot to enable or disable it.
• Select a rectangular area by dragging the mouse holding down the right button to enable the dots
within the area.
• Select a rectangular area by dragging holding down the Shift key and the right button of the mouse
to disable the dots within the area.
44/100