Mitsubishi DX-PC200 Operation Manual page 33

"DVR Type":
From the dropdown menu, select the model number of the recorder to be connected. If the
model number of the recorder is not listed in the menu, the DX-PC200 cannot connect to the
recorder.
"DVR Name":
Enter the name of the registered recorder in this box. The name you entered in this box will
be displayed on the camera list. For example, enter the name of the camera-installed place
in this box. Freely use this box.
"IP Address":
Set the IP address of the recorder to be connected.
"Port No.":
Set the port number of the recorder to be connected. If the default port number is not
changed on the recorder side, use the default port number "53705".
"Use":
Enter a check in the check box if you want to use the camera. Erase the check mark from the
check box if you do not use the camera. If the check mark is erased from the check boxes of
all the unnecessary cameras, the camera list will be simplified, and the layout switching
operation will be smoothly performed.
"Ch":
Indicates the camera number (channel number) of the recorder.
"Camera Name":
Enter the camera name. The camera name you entered will be displayed at the upper left
section of the camera list and the Camera window. The name of the camera-installed place
can be entered as the camera name. Freely use this box.
"Use more than one port forward":
If the IP masquerade is used for registration, the IP addresses will be different from those of
the recorder main bodies. In this case, even if the IP address of an event is received, it is
difficult to identify the recorder that issued the event. To easily identify the recorder, enter a
check in this check box. The extension tab will be displayed. Enter the IP addresses of the
33/100