Mitsubishi Electric DLP XD700U User Manual page 50

Advanced features (continued)
Connection
For details of the connection, see "LAN control UTILITY operation manual" in the CD-ROM.
When Standby Mode of the Efficient Mode menu in the Installation menu of the projector is set to Low, the LAN
network is disabled. To enable the LAN network, set Standby Mode to LAN. (See page 27.)
Configure the initial network settings first.
Using the User Manual
The User Manual for LAN Control Utility is prepared in the Portable Document Format (PDF) in the CD-ROM.
Opening the User Manual:
1. Load the CD-ROM into the CD-ROM drive.
2. Open CD-ROM "PROJECTOR."
3. Double-click on "MANUAL_LAN.HTML" within the CD-ROM. A language selection list for the User Manual will be
displayed.
4. Move the mouse pointer to the desired language and click.
PJLink™ supported commands
The table below shows commands to control the projector using the PJLink™ protocol.
Command Description
POWR Power control
Inquiry about the power state
INPT Input switching
Inquiry about input switching
AVMT Mute control
Inquiry about the mute state
Inquiry about the error state
Inquiry about the lamp state
Inquiry about the available inputs
Inquiry about the projector name
Inquiry about the manufacturer name
Inquiry about the model name
Inquiry about other information
Inquiry about the class information
This projector is fully compliant to the specifications of JBMIA PJLink™ Class 1. It supports all the commands defined by
Remark (Parameter)
1 = Power on
1 = Power on
2 = Cooling down
3 = Warming up
11 = Computer1
21 = Video
31 = HDMI
41 = PC Less Presentation
51 = LAN Display
31 = Video and audio mute enable
1st value (1 to 5 digits): Cumulative lamp operating time (This item shows
a lamp operating time (hour) calculated based on
that Lamp Mode is Low.)
The following value is returned.
"11 12 21 22 31 41 42 51"
The projector name set on the Network Config menu or the Crestron
RoomView Setup window is returned.
"MITSUBISHI" is returned.
No other information is available. No parameter is returned.
"1" is returned.
12 = Computer2
22 = S-Video
42 = USB Display