Mitsubishi Electric DLP XD700U User Manual page 29

Menu operation (continued)
Network Config menu
Network Config
SET
Projector Name
On
Network Certification
OK
Network Password
OK
IP Config
OK
Wireless Setting
AMX Device Discovery Off
Network Initialization OK
Network Restart OK
Adjust
MENU
Select
ITEM
Projector Name
Network Certification
Network Password
IP Config
DHCP
IP Address
Subnet Mask
Default Gateway
MAC Address
DHCP Function
Start IP Address
End IP Address
IP Config Setup
Wireless Setting
SSID
Channel
Encryption
Wireless Setup
AMX Device Discovery
Network Initialization
Network Restart
DHCP
IP Address
Subnet Mask
Default Gateway
MAC Address
DHCP Function
Start IP Address
End IP Address
IP Config Setup
Exit
Adjust
Select
SETTING
xxxxxxxx...
SET
On / Off
OK
OK
On / Off
xxx-xxx-xxx-xxx
xxx-xxx-xxx-xxx
xxx-xxx-xxx-xxx
xx-xx-xx-xx-xx-xx
On / Off
xxx-xxx-xxx-xxx
xxx-xxx-xxx-xxx
OK
OK
xxxxxxxx...
SET
Auto / 1 / 2 / 3 / 4 / 5 /
/ Off /
SET
WEP 128bit(ASCII) /
WEP 64bit(ASCII) /
WEP 128bit(HEX) /
WEP 64bit(HEX) /
WPA-PSK(ASCII) /
WPA2-PSK(ASCII) /
WPA-PSK(HEX) /
WPA2-PSK(HEX)
OK
Off / On
OK
OK
IP Config
On
169 254 0 220
- - -
255 255 0 0
- - -
169 254 0 1
- - -
xx-xx-xx-xx-xx-xx
Off
169 - 254 - 0 221
-
169 254 254 254
- - -
OK
MENU Exit
FUNCTION
Displays Projector Name. Displays Projector Name in blank when
Projector Name is not set.
Set Projector Name. Enter up to 15 character alphabets (capital/small),
numeric characters, or marks.
Select whether to enable the network certification or not. Select On for
normal use.
Set the password for PJLink certification.
Select this setting for IP Configuration. (See page 35.)
Use this setting when you obtain IP Config automatically by DHCP
server.
Displays IP Address.
Displays Subnet Mask.
Displays Default Gateway.
Displays MAC Address.
Use this setting when the projector behaves as a DHCP server.
Displays Start IP Address. However, Start IP Address is not set as
factory default, and cannot be displayed.
Displays End IP Address. However, End IP Address is not set as
factory default, and cannot be displayed.
Set the IP configuration.
Select this setting for wireless configuration.
Displays SSID.
Set SSID. Enter up to 32 characters (alphabets or numeric characters).
Select the wireless channel.
Select the wireless encrypted communication.
Set the wireless configuration.
Use this setting when using an AMX controller.
Initializes network setting.
Restarts network function.
EN-29
Wireless Setting
SET
SSID
Auto
Channel
Off
Encryption
OK
Wireless Setup
Adjust
MENU
Select
Exit