1.4.1.3. Basic menu operation
Adjustments should be conducted with the remote control in advanced mode.
(You can also use the adjustment software, "Wallaby" (chapter 4, on page 99)).
•
[POWER ON] button: To turn on after main power switch on.
•
[MENU1] button: To display the input memory menus.
•
[MENU2] button: To display the display memory menus while the input board is attached.
•
[MENU2] button (press and hold): To display the system memory menus.
•
Up/down button: To select menu items.
•
[ENTER] button: To enter each adjusting menu. Some items indicate the lower menu layer.
•
Left/right button: To change an adjusting value.
•
[ESC] button: To exit menus.
•
[NORMAL] button: To reset an adjusting value. In reply to appeared "RESET OK?" message,
press [ENTER] button. You can exit the menu without resetting by [ESC] button.
[NORMAL] button also executes automatic input signal scanning during input memory
menus displaying.
•
[FUNC] button: Remote ID setting (chapter 1.4.1.4).
•
[TEST] button: To display test patterns (chapter 3.3, on page 91). Even while any menus
are displayed on screen, the test patterns on/off and selecting are available.
•
[R][G][B] buttons: To switch muting/displaying of primary colors. It works regardless of
remote ID setting.
Press-and-hold the button can always display the selected color. This function is helpful
when you display the same color across a display wall, which mixes color displaying/muted
cubes. Just pressing may unintentionally mute the color in other cubes.
•
Number buttons: To call a display memory directly with 3-digit number while there is no
menu on screen. For instance, press 001 to call the display memory 1.
•
[DISPLAY] button: To show status information.
LAMP TIMER
INPUT
SYSTEM ID
LAMP A NEW
LAMP B USED
NO SIGNAL
Status information ([DISPLAY] button)
1.4.1.4. Remote ID
Remote ID is used to operate remote control toward a specified screen in a display wall. Even
while any menus are displayed on screen, remote ID can be switched.
Specify a set ID by [FUNC] button and 2-digit number in advanced mode, which ID has been set
in the dipswitch. When you control only ID=1 cube, press [FUNC]+[0]+[1]. It can be also selected
by left/right button after the [FUNC] button. And then press [ENTER] button to confirm.
Pressing [FUNC]+[0]+[0] buttons enable remote control toward all cubes.
Lamp operating time
99999H
Input port
ANALOG
Set ID
01
BUSY
STANDBY
Lamp status
Comment
(In
C
h
a
n
g
e
r
C
h
a
n
g
e
r
27
! ANALOG
F/W VER
H/W VER
SET TIMER
MASTER
L.SENSOR
)
Detail status information
([DISPLAY] button press-and-hold)
ID01
P01.50A
Firmware version
12.19
FPGA version
99999H
Set operating time
Master/slave setting
125
Luminous sensor value
REV 2.4