Table of Contents
Advertisement
Setting Modem Port
To use communication software,
1.
Turn on your notebook.
2.
Press the F2 key when the message Press <F2> to enter Setup appears.
3.
On the Advanced page of the Setup Utility, set the COM1/COM2 Function to
FAX Modem/IR or Serial Port/FAX Modem.
4.
If you assign the modem to COM1, set the COM1 Port to 3F8, IRQ4. If you
assign the modem to COM2, set the COM2 Port to 2F8, IRQ3.
5.
Press the Esc key and select Save Changes & Exit.
6.
In the communication software, set the items such as COM ports, baud rate, etc.
Refer to the software manual or online help or the manual of Windows 95.
Using communications software
Before starting to use communications software, set Power Management item in the
5
Power in the Control Panel to Off. Also, do not enter suspended mode while using
communications software.
If a power management function becomes active during communication,
correct data transfer may not be possible.
You must set parameters such as modem speed (baud rate) and line type (pulse
dialing or tone dialing) within the communications software you are using. For
details, please refer to the documentation of the software.
5-4 Modem
Advertisement
Table of Contents
