Sharp PC-W100T Operation Manual page 51

When entering or returning from suspended mode, be sure to observe the
following precautions. Otherwise, the notebook may not operate correctly
after the notebook has resumed from the suspend mode.
Do not operate the keyboard, Glide Point or mouse in the process of
entering or returning from suspended mode.
Before activating suspended mode, terminate any optical or modem
communications and make sure that no video or audio playback is in
progress.
In Windows 95, set the Power Management item to Advanced.
When using a modem, set the Modem Power when Suspend to RAM
item to Enabled.
When using a PC Card, set the PCMCIA Power when Suspend to RAM
item to Enabled.
Resuming from Suspend Mode
Normally, resuming from a suspend mode is triggered as follows:
By the power switch.
If Suspend to RAM is active, by pressing any key, or by calling up the modem.
Also, if the suspend state was entered by closing the cover, operation resumes
when the cover is opened (as long as battery voltage is sufficient).
However, if the suspend state was caused by the battery capacity dropping below
a certain level, operation can be resumed only after AC power is connected or a
charged battery installed, and then only by the power switch.
When a resume event occurs, the system returns to where it was when suspend mode
was entered, e.g., software applications open, the display reappears, etc.
Using Your Notebook 3-5
3