Using A Microphone; Turning On The Lights (At-80Sl) - Roland Atelier AT-60SL Owner's Manual

Before You Start Playing

Using a Microphone

The AT-80SL/60SL is equipped with a Mic jack.
Since this instrument has a Mic In jack, you can use a
microphone to enjoy a variety of possibilities such as singing
along with your performance, or singing along with SMF
music files (sold separately).
fig.00-32
1.
Connect your microphone to the [Mic In] jack
underneath the left side of the keyboard.
2.
Use the [Mic Volume] knob to adjust the volume
level for the microphone.
You can adjust the depth of the echo applied to sound from
the microphone (p. 194).
The microphone must be purchased separately. When
purchasing a microphone, please consult the vender where
you bought the AT-80SL/60SL.
NOTE
(AT-80SL only)
If the Input switch is set to "RSS," RSS reverb will be applied
to the sound from the microphone. You can use the [Mic
Volume] knob to adjust the microphone volume (p. 210).
Some Notes on Using a Microphone
fig.00-31
• To avoid disturbing others, be careful of the volume
level when playing late at night or very early in the
morning.
• When connecting a microphone to the AT-80SL/60SL, be
sure to lower the volume. If the volume control is too
high when the microphone is plugged in, noise may be
produced by the speakers.
• Howling could be produced depending on the location
of microphones relative to speakers. This can be
remedied by:
• Changing the orientation of the microphone.
• Relocating the microphone so it is farther from the
speakers.
• Lowering volume levels.
22

Turning On the Lights (AT-80SL)

After turning on the power, turn on the [Illumination] switch
(located underneath the left-hand side of the keyboard).
fig. 00-33
On
Illumination
The panel illumination of the instrument will light.
Cautions When Using Illumination
fig.00-31
When the illumination is used for an extended period, the
light bulbs and the metal parts near the light bulb (see
diagram below) will become hot. Be careful not to touch
these areas. In particular, be careful of the following
locations.
1.
Panel illumination light bulb
Do not touch the light bulb or nearby parts. When
closing the lid, be sure to hold the handles.
2.
Metal fittings of the cover
After closing the lid, do not touch this area.
The bulbs used for illumination can be replaced. For details
on replacing a bulb, refer to "Replacing the Illumination
Bulbs (AT-80SL Only)" (p. 251).
fig.00-35
Illumination Switch
1
2