Battery Installation And Battery Clamp (Engine Cover) Assembly - Fisher-Price BARBIE Splash 74350 Owner's Manual & Assembly Instructions

H
IMPORTANT! Use only a Power Wheels
tery with a Power Wheels
of any other battery or fuse will damage your vehicle. Make
sure that you charge the battery for at least 18 hours using
the enclosed Power Wheels
operating your vehicle for the first time. Charge the battery
for at least 14 hours after each use of the vehicle. Never
charge the battery longer than 30 hours. Failure to follow
these instructions may damage your battery and will void
your warranty.
1
Hood
• Lift the hood.
• Place the battery in the battery compartment. Make
sure the battery connector extends toward the motor
harness connector.
2
Motor
Harness
Connector
• Squeeze the tabs on each side of the motor harness
connector. Plug the battery connector into the motor
harness connector.
Note: If the battery connector will not plug into the motor
harness connector, turn it over and try again. Do not force
the battery connector into the motor harness connector.
Battery Installation and Battery Clamp
(Engine Cover) Assembly
® Type H 6 Volt bat-
25 Amp fuse installed. Use
®
® Type H 6 Volt charger before
Battery
Connector
Motor
Harness
Connector
Battery
Connector
3
Battery
• Fit the battery clamp (engine cover) over the battery,
motor harness connector and battery connector.
• Insert two #8 x 18 x 1" screws through the holes in the
battery clamp (engine cover) and into the vehicle body.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
4
• Lower the hood. Lift the hood latches and fit the short
tabs onto the notches on the hood to fasten it.
16
Battery Clamp
(Engine Cover)
Hood
Hood
Latches