Advertisement
Back Base
Tapered Leg Tube
8
Front Base
• Identify the back and front base. The front base has tapered leg
tubes. You will use the back base for the next assembly step.
Frame Decorated Side
Back Base Hole
Screw Retainers
9
• Position a frame so that the decorated side is outward.
• Insert the back leg of a frame into the back base.
• Fit a screw retainer over the hole in the back base, as shown.
• Insert a #10 x 2.2 cm black screw through the screw retainer
and back base. Insert the back leg of a frame into the back
base. Tighten the screw.
• Repeat this procedure to attach the other frame back leg
to the other side of the back base.
Hint: The #10 x 2.2 cm black screws may have been assembled to the
screw retainers.
Assembly
#10 x 2.2 cm Black Screw - 2
Frame Back Legs
Screw Retainer - 2
Back Base Hole
Seat Height Adjusters
10
• While pressing the levers on the seat height adjusters, lift them
to position 4 on the frame front legs, as shown.
11
Seat Bottom Tubes
• Fit the seat assembly between the two frames.
• Insert the seat bottom tubes into the sockets in each seat
height adjuster.
Hints:
• Be sure the seat height adjusters are in the same position (position 4).
• You may need to push the frames apart slightly to fit the seat bottom
tubes into the seat height adjuster sockets.
6
6
6
Position 4
Press Lever
Seat Assembly
Sockets
Advertisement
