Crossover Network Setup - Kenwood DNX7280BT Instruction Manual

2
Select a speaker size using [2] and
[3]. The speaker size is different
depending on the speaker type and
the unit.
Front
OEM, 10 cm, 13 cm, 16 cm, 17 cm, 18 cm, 4x6,
5x7, 6x8, 6x9, 7x10
Rear
None, OEM, 10 cm, 13 cm, 16 cm, 17 cm, 18
cm, 4x6, 5x7, 6x8, 6x9, 7x10
Subwoofer
None, 16 cm, 20 cm, 25 cm, 30 cm, 38 cm over
NOTE
• Select "None" if you have no speakers.
Front/Rear/Subwoofer
Standard, Wide, Middle, Narrow

Crossover network setup

You can set a crossover frequency of
speakers.
1
Touch the speaker to set the crossover
in the Speaker Select screen.
2
Touch [X'over].
X'over screen appears.
3
Set each item as follows.
Phase*
Sets the phase of subwoofer output.
The phase is reversed 180 degrees when set to
"Reverse. "
HPF FREQ
High Pass Filter adjustment. (When front or rear
speaker is selected on Speaker Select screen)
LPF FREQ
Low Pass Filter adjustment. (When subwoofer
is selected on Speaker Select screen)
Slope
Sets a crossover slope.
* T his function is available in the specific
situation.
Only when "Subwoofer" is set to
"ON" in "Speaker Setup".
Only when "Subwoofer" is
set to "ON" in "Speaker Setup" and "LPF
FREQ" is set to other than "Through".
Car type (DTA) setup
You can setup the car type and speaker
network, etc.
1
Touch [Car Type] in the Audio SETUP
screen.
Car Type screen appears.
2
Select your car type from the list.
NOTE
• You may not be able to select your car type from
the list.
• If your car type is selected, the Delay Time
Alignment and Equalizer is set automatically (for
timing adjustment of sound output for each
channel) to have the highest surround effects.
Return to the Top page
Audio Setting Up
79