Detaching The Front Panel - Kenwood DNX7210BT Instruction Manual

Return to the Top page
Basic Operations
SD card
1
DNX7210BT: Press the <0>
button for 1 second to open the
front panel.
0
The panel fully opens.
DNX5210BT/ DNX5510BT:
Detach the front panel.
NOTE
• For how to detach the panel, see Detaching The
Front Panel (P.15).
2
Hold the SD card as the diagram
below and insert it into the slot
until it clicks.
Notched section
Labeled side
The unit loads the card and playback
starts.
● To remove:
Push the SD card until it clicks and then
remove your finger from the card. The
card pops up so that you can pull it out
with your fingers.
14 14
External device
1
Insert the plug into the AV-IN jack.
D
etaching The Front
Panel
You can detach the front panel to prevent
theft.
1
Press the <0> button for
1 second to open the front panel.
0
NOTE
• You can set the front panel to open automatically
when the ignition is turned off. See Monitor
angle control (P.74).
2
Detach the panel as the diagrams
below.
3
2
1
4
NOTE
• The attaching plate closes automatically in about
10 seconds after the front panel is released.
Remove the panel before this happens.
Return to the Top page
Basic Operations
1
Detach the panel as the diagrams
below.
2
1
● After detaching:
Put the panel in the protective bag
supplied with the unit.
NOTE
• To prevent deterioration, do not touch the
terminals of the unit and faceplate with your
fingers.
• If the terminals on the unit or faceplate get dirty,
wipe them with a clean soft dry cloth.
15