Resetting The Unit - Kenwood DNX7210BT Instruction Manual

Return to the Top page
Troubleshooting
Error Message Cause
USB Device The connected USB device is rated
Error!! a current capacity higher than the
allowable limit.
Authorization Connection to the iPod has failed.
Error
Update your The iPod's software is an older
iPod version which the unit can not
support.
Navigation The communication error has
Error. Please occurred due to severely cold
turn on power temperature.
again later.
98 98
Solution
Check the USB device. Some trouble may have
occurred to the connected USB device.
Change the source to any source other than
USB. Remove the USB device.
• Remove the iPod and then reconnect it.
• The unit does not support the iPod.
See Connectable iPod/iPhone (P.102).
The unit may not support the connected iPod
model.
Confirm that the software for the iPod is the
latest version.
See Connectable iPod/iPhone (P.102).
Turn on power again after warming your car
interior.

Resetting The Unit

If the unit or the connected unit fails to operate properly, reset the unit.
1
Press the <Reset> button.
The unit returns to factory settings.
NOTE
• Disconnect the USB device before pressing the <Reset> button. Pressing the <Reset> button with the USB device
connected can damage the data stored in the USB device. For how to disconnect the USB device, see How To
Play Media (P.13).
• When the unit is turned on after resetting, the Initial SETUP screen appears. See Initial setup
Return to the Top page
Troubleshooting
(P.11).
99