Super Stitch Pattern; Height And Position Of The Presser Foot - JUKI HZL-30Z Service Manual

4-17 Super stitch pattern

How to adjust 1. Select the hemming pattern and perform a trial sewing.
2. Check that the needle enters into the same needle entry holes of the left-side in
3. Insert a screwdriver into the small hole of the bottom cover and turn the adjusting
4. After performing the adjustment, check also "4-16 reverse stitch" and "4-19 button

4-18 Height and position of the presser foot

Remove the face plate.
How to adjust 1. Set the presser foot for zigzag stitch, and when the presser foot lever is raised,
2. At this time, determine the rotating direction of the presser bar so that the groove of
* Place screwdriver of 6 mm shaft dia. under the presser foot when the feed dog is
forward/backward stitches.
screw.
Super stitch pattern opens
Super stitch pattern overlaps
hole".
Under side cover
Adjusting screw
Needle entry
holes
loosen the setscrew of the presser bar guide and move the presser bar up or down
so that the presser foot is 6 mm above the upper face of the throat plate.
[2.5 mm hexagon screwdriver]
the feed dog is parallel to the presser foot.
lowered and move the presser bar up or down. The screwdriver is available as a
substitute of the gauge. (Standard value: 6.0 + 0.5/0 mm)
6 mm ø 6 screwdriver
Turn the adjusting screw clockwise.
Turn the adjusting screw counterclockwise.
Hole for adjustment
-16- -16- -16- -16- -16-