Adjusting The Height Of The Knee Lifter; Installation Of Thread Stand - JUKI LH-3500 Series Instruction Manual

3-3. Adjusting the height of the knee lifter

WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
1

3-4. Installation of thread stand

Assemble the thread stand, set t up on the machne table usng the nstallaton hole n the table and
tghten nut 1 gently.
When you use power suppled by the overhead power lne, pass the power supply cord through hollow
spool rest rod 2 .
)
2)
2
3
2
1
– 7 –
The standard heght of the presser foot lfted
usng the knee lfter s 2 mm.
You can adjust the presser foot lft up to 3
mm usng knee lfter adjust screw 1 .
Do not operate the sewing machine in the
state that the presser foot 3 is lifted by
12 mm or more since the needle bar 2
comes in contact with the presser foot 3 .