Removing And Attaching The Foot Holder; Changing The Presser Foot; Presser Foot Lifter - Janome Sewing Machine Instruction Book

q
w
z
x
w
e
e
w
q
q
w
e
e
w
q

Removing and Attaching the Foot Holder

CAUTION:
Turn OFF the power switch before detaching or
attaching foot holder.
• Removing the foot holder
Remove the setscrew q by turning it counterclockwise
with a screwdriver.
• Attaching the foot holder
Match the hole in the foot holder w with the threaded
hole in the presser bar e. Fit the setscrew q into
the hole. Tighten the setscrew q by turning it clockwise
with a screwdriver.
q Setscrew
w Foot holder
e Presser bar

Changing the Presser Foot

CAUTION:
Turn OFF the power switch before changing the foot .
Always use the proper foot for the selected pattern.
The wrong foot can cause the needle to break.
• Removing the presser foot
Raise the needle to its highest position by turning the
handwheel counterclockwise. Raise the presser foot,
and press the lever q on the back of the foot holder.
• Attaching the presser foot
Place the selected presser foot so that the pin e on
the foot lies just under the groove w on the foot
holder. Lower the presser bar to lock the foot into
the place.
q Lever
w Groove
e Pin

Presser Foot Lifter

The presser foot lifter q raises and lowers the presser
foot.
You can raise the foot about 1/4˝ (0.6 cm) higher than the
normal up position w for easy removal of the presser
foot, or to help you place thick material under the foot.
q Presser foot lifter
w Normal up position
e Highest position
8