RIDGID 300 Compact Operator's Manual page 8

300 Compact Pipe and Bolt Threading Machine
The stand stop bracket is not required or supplied
with the No. 100A Leg and Tray Stand.
300 Compact
1233, 1822
1224
(Front)
300 Compact
1233, 1822 (Rear)
535-A/535
Manual - 2001
535 (Rear)
Pre-2001
Detail Section
Figure 3 – Stand Assembly
4. Insert axle into frame and secure it with a
washer and nut. Position stand stop bracket so that
the end of the bracket is held in place by the axle
shaft. Slide a wheel onto the axle. Slide a flat wash-
er over the axle and install a cotter pin to hold the
wheel on the axle.
5. Mount machine to the stand using four (4) bolts
that mount into each corner of the base.
For proper balance and operation, RIDGID
CAUTION
machines must be mounted through the appropriate
holes in the legs (Figure 3).
6
(Front)
535 (Front)
Pre-2001
535-A/535
Manual - 2001
3 / - 16 x 2 1 / Bolt
8 2
4 Required
/ lock
1
2
Figure 4 – 300 Compact On 200A Wheel and Cabinet Stand
Figure 5 – 300 Compact On 100A Leg and Tray Stand
Mounting Machine To Bench
1. If a stand is not used, the machine should be mount-
ed to a stable bench. To mount the unit on a bench,
use four (4)
ner of machine base.
WARNING
a stable stand or bench may result in tipping and serious
injury.
Ridge Tool Company
1 / bolts in holes provided at each cor-
4
Failure to mount the threading machine to