Walls
1
•
Fit the upper and lower walls together, as shown.
4 Screws
2
•
Insert four screws into the holes in the wall assembly and tighten.
Assembly
3
•
Place the bases on a flat surface, as shown.
•
Fit the wall assembly into each base and push to
Hint: The wall is designed to fit the bases one way. If it does not
seem to fit, turn or switch one or both bases around and try again!
Ramp
Labeled 2
4
•
Locate the ramp labeled with a
•
Fit the ends of the ramp into the slots in the wall, as shown.
Hint: The tab at the top of the ramp has a blue dot on it. Match
this dot to the slot with the blue dot.
5
Bases
Top View
Top View
2.
"snap" in place.
Blue Dots