Advertisement
15-1917.fm Page 32 Monday, July 19, 1999 12:25 PM
IF YOU HAVE PROBLEMS
MANUAL CODE SEARCH
If the Phone Up 4 does not operate your remote
controlled devices when you first set it up, you
might be able to search the Phone-Up 4's library
for a code that works.
Follow these steps to search the Phone Up 4's
entire library.
1. Manually turn on the device you want to set
up and press the corresponding device key
on your Phone Up 4 (
2. Aim the Phone Up 4 at the device you want
to operate.
3. Press and hold
SETUP
blinks twice. Release
The red light blinks twice again.
4. Slowly alternate between pressing
the device key.
For example, if you are searching for the
code to operate your TV, use the following
sequence.
SETUP 9 9 1 PWR TV PWR TV PWR
Each time you press
advances to the next code in the library.
5. When your device responds, immediately
press
to lock in the device code.
SETUP
Note: Because of the large number of codes
in the Phone Up 4's library, this procedure
can take several minutes. If your device
turns off during the search, but does not
operate after you lock in a code, begin the
search again, pausing longer between key
presses.
If necessary, repeat these steps for each
device.
Need help? Call 1-800-950-7044
32
,
,
, or
).
TV
VCR
CBL
AUX
until the red light
and press
.
SETUP
9 9 1
and
PWR
...
, the Phone Up 4
TV
Hide quick links:
Advertisement
