Introduction; Rating Plate; Installation; Siting - U.S. Range U SERIES Installation And Operation Manual

INTRODUCTION

1 . Check crate for possible damage sustained during transit .
Carefully remove unit from crate and again check for
damage . Any damage to the appliance must be reported
to the carrier immediately .
2 . The wires for retaining packing material must be
removed from units . Any protective material covering
stainless steel parts must also be removed .
3 . All equipment is supplied with 6" (152mm) legs unless
specified to be dais for cove base mounting, casters
or deck mount flanged feet . Units 48" (1219mm) and
60" (1524mm) wide have legs factory mounted . Base
mounting is required when range is being installed on a
combustible floor .

INSTALLATION

This product has been certified as commercial cooking
equipment and must be installed by professional personnel
as specified . THIS APPLIANCE IS NOT RECOMMENDED FOR
RESIDENTIAL INSTALLATION .
We suggest installation, maintenance and repairs should
be performed by your local Garland/US Range authorized
service agency .

Siting

The floor on which the appliance is to be sited must be
capable of adequately supporting the weight of the
appliance and any ancillary equipment . Units with ovens
must be fitted with legs if installed on a combustible floor .
Adequate clearance must be provided for servicing and
proper operation .
Page 6
4 . The type of gas and supply pressure that the equipment
was set-up for at the factory is noted on the rating plate
and on the packaging . This type of gas supply must be
used .
5 . Do not remove permanently affixed labels, warnings or
rating plates from the appliance, for this may invalidate
the manufacturer's warranty .

Rating Plate

All burner input rates are shown on the rating plate, which is
located behind the lower front drop down panel under the
oven door .

Appliances Equipped With Casters

1 . The installation shall be made with a connector that
complies with the Standard for Connectors for Moveable
Gas Appliances, ANSI Z21 .69/CSA 6 .16, Addenda
Z21 .69B-2006/CSA 6 .16B-2006 (or latest edition), and a
quick-disconnect device that complies with the Standard
for Quick Disconnects for Use with Gas Fuel, ANSI Z21 .41/
CSA 6 .9, Addenda Z21 .41A-2005/CSA 6 .16A-2005 (or
latest edition)
2 . The front casters of the appliance are equipped with
brakes to limit the movement of the appliance without
placing any strain on the connector or quick disconnect
device or its associated piping .
3 . Please be aware that required restraint is attached to a
cut out hole in side panel, and if disconnection of the
restraint is necessary, be sure to reconnect the device
after the appliance has been returned to its original
position .
Part # 4523341 Rev 2 (03/04/10)