Set Supervisor/User Password - Fujitsu MS-6191 User Manual

Mainboard MS-6191

3.11 Set Supervisor/User Password

You can set either supervisor or user password, or both of them. The differences are:
Supervisor password : can enter and change the options of the setup menus.
User password :
ENTER PASSWORD:
Type the password, up to eight characters in length, and press <Enter>. The password typed now will clear any previously
entered password from CMOS memory. You will be asked to confirm the password. Type the password again and press
<Enter>. You may also press <Esc> to abort the selection and not enter a password.
To disable a password, just press <Enter> when you are prompted to enter the password. A message will confirm the
password will be disabled. Once the password is disabled, the system will boot and you can enter Setup freely.
PASSWORD DISABLED.
When a password has been enabled, you will be prompted to enter it every time you try to enter Setup. This prevents an
unauthorized person from changing any part of your system configuration.
Additionally, when a password is enabled, you can also require the BIOS to request a password every time your system is
rebooted. This would prevent unauthorized use of your computer.
You determine when the password is required within the BIOS Features Setup Menu and its Security option. If the Security
option is set to "System", the password will be required both at boot and at entry to Setup. If set to "Setup", prompting only
occurs when trying to enter Setup.
Can only enter but do not have the right to change the options of the setup menus. When you select
this function, the following message will appear at the center of the screen to assist you in creating a
password.
54