Set Supervisor/User Password - Fujitsu GA-7VAXFS User Manual

Set Supervisor/User Password

CMOS Setup Utility-Copyright (C) 1984-2002 Award Software
Standard CMOS Features
Advanced BIOS Features
I n t e g r a t e d P e r i p h e r a l s
Power Management Setup
P n P / P C I C o n f i g u r a t i o n s
P C H e a l t h S t a t u s
Frequency/Voltage Control
E s c : Q u i t
F 8 : Q - F l a s h
When you select this function, the following message will appear at the center of the screen to
assist you in creating a password.
Type the password, up to eight characters, and press <Enter>. You will be asked to confirm the
password. Type the password again and press <Enter>. You may also press <Esc> to abort the
selection and not enter a password.
To disable password, just press <Enter> when you are prompted to enter password. A message
"PASSWORD DISABLED" will appear to confirm the password being disabled. Once the password
is disabled, the system will boot and you can enter Setup freely.
The BIOS Setup program allows you to specify two separate passwords:
SUPERVISOR PASSWORD and a USER PASSWORD. When disabled, anyone may access
all BIOS Setup program function. When enabled, the Supervisor password is required for entering the
BIOS Setup program and having full configuration fields, the User password is required to access only
basic items.
If you select "System" at "Password Check" in Advance BIOS Features Menu, you will be
prompted for the password every time the system is rebooted or any time you try to enter Setup Menu.
If you select "Setup" at "Password Check" in Advance BIOS Features Menu, you will be
prompted only when you try to enter Setup.
L o a d F a i l - S a f e D e f a u l t s
L o a d O p t i m i z e d D e f a u l t s
Set Supervisor Password
Enter Password :
Enter Password:
Set User Password
S a v e & E x i t S e t u p
E x i t W i t h o u t S a v i n g
F 1 0 : S a v e & E x i t S e t u p
Change/Set/Disable Password
F i g u r e 1 2 : P a s s w o r d S e t t i n g
- 4 5 -
: S e l e c t I t e m
BIOS Setup