Setting Up The Server Connection; System Status Check - Fujitsu Eternus DX60 User Manual

Chapter 4 Setup
>

4.5 Setting up the Server Connection

4
4.5 Setting up the Server Connection
Perform the settings required to connect to the server and install the required drivers. Perform
the settings required for network devices connecting the server and the ETERNUS DX60/DX80.
Check the connection between the server and the device.
Refer
4.6

System Status Check

Check the following status using GUI or CLI.
• ETERNUS DX60/DX80 parts status
• RAID group status
• Volume status
For status check details, refer to the "ETERNUS DX60/DX80 Web GUI User Guide".
Refer
P3AM-3042-03ENZ0 ETERNUS DX60/DX80 Disk storage system User Guide
Click the [Set] button.
The set information is sent to the Remote Support center, and the connection between the
ETERNUS DX60/DX80 and Remote Support center is checked. The result of connection
check is sent to "Mail Address".
"ETERNUS DX60/DX80 Web GUI User Guide"
"ETERNUS Disk storage systems Server Connection Guide (Fibre Channel)"
"ETERNUS Disk storage systems Server Connection Guide (iSCSI)"
"ETERNUS Disk storage systems Server Connection Guide (SAS)"
Manuals of the drives to be installed
This section explains the procedure using GUI. For the setup using the CLI
commands, refer to "ETERNUS DX60/DX80 Command Line Interface (CLI)
User's Guide".
"ETERNUS DX60/DX80 Web GUI User Guide"
156
End of procedure
Copyright 2009 FUJITSU LIMITED