Modifying Phone's Configuration Using The Web Interface - Polycom VVX 1500 D Deployment Manual

Modifying Phone's Configuration Using the Web Interface

Note
Note
You can make changes to the phone's configuration through the web interface
to the phone. The factory default username and password for the web interface
is Polycom and 456 respectively (the username is case sensitive).
Blind transfer, call recording, picture frame, corporate directory (LDAP Integration),
and phone server redundancy cannot be enabled/disabled through the web
interface. You cannot change the displayed language through the web interface.
You must make changes for these features through the configuration files. Refer to
Deploying Phones From the Provisioning Server
Changes made through the web interface are written to the override file (highest
priority). These changes remain active until Settings > Advanced > Admin
Settings> Reset to Default > Reset Local Config... is performed.
To configure the phone through the web interface:
Using your chosen browser, do the following:
>>
To get the phone's IP address, press the Menu key, and then selecting
a
Status > Platform > Phone. Scroll down to see the IP address.
Enter the phone's IP address as the browser address.
b
You will be prompted for the web interface username and password.
A web page similar to the one shown below appears.
Setting Up the Polycom VVX 1500 D Phone
on page 2-12.
2 - 7