Of The Mower - Toro TimeCutter Z4220 Operator's Manual

GB05192
Figure 56
1, Mower deck 5, Spring
2, Grass deflector 6, Nut (318 inch)
3. Grass deflector bracket 7, Short stand-off
4, Rod
2, Remove the nut (3/8 inch) from the rod under the
mower (Figure 56).,
3, Slide the rod out of the short stand-off, spring, and
grass deflector (Figure 56). Remove the damaged
or worn grass deflector.
4_ Replace the grass deflector (Figure 56)
5 Slide rod, straight end, through the rear grass
deflector bradlet.
.
7_
Place the spring on the rod, with end wires down,
and between the grass deflector brackets, Slide rod
through second grass deflector bracket (Figure 56),,
Insert rod at front of grass deflector into short
stand-off on deck Secure rear end of rod into the
mower with a nut (,3/8 inch) (Figure 56)
important:
The grass deflector must be spring
loaded in the down position. Lift the deflector
up to test that it snaps to the full down position.
Cleaning
Washing the Underside of the
Mower
Service Interval: Before each use or daily--Clean the
mower housing
_Tash the underside of the mower after each use to
prevent grass buildup for Janproved mulch action and
clipping dispersal,
1,. Park the machine on a level surface and disengage
the blade control switch
2, Move the motion control levers outward to the
park position, stop the engine, remove the key, and
wait for all moxdng parts to stop before leaving the
operating position.
3, Attach the hose coupling to the end of dae mower
washout fitting, and turn the water on high
(Figure ST).
Note:
Spread petroleum jelly on the washout fitting
O-_.ng to make Lhe coupling slide on easier and
protect the O-ring.
3
2
'1,
2.
Figure 57
Washout fitting 3,, O-ring
Hose 4, Coupling
4.. Lower the mower to the lowest height-of-cut,,
5 Sit on the seat and start the engine E,ngage the blade
control switch and let the mower run for one to
three minutes
6, Disengage the blade control svdtch, stop the engine,
and remove the ignition key. Wait for all moving
parts to stop
7, Turn the water off and remove the coupling from
the washout fitting,,
41