Toro TimeCutter Z4220 Operator's Manual page 28

2. Park the machine so that the &ain side is slightly
lower than the opposite side to assure the oil drains
completely.
3 Disengage the blade control switch _Lndmove the
motion controls outward to the park position
4. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
5. Clean the area around the &ain valve and on the
machine frame. Locate the oil drain hose and slide
it over the drain valve (Figure 28).
.
2,,
.
Figure 28
Oil drain hose 3, Hote in frame
Drain valve 4, Oil filter
Place the opposite end of the oil drain hose through
the drain hole in the frame (Figure 28)
Place a pan underneath machine dii'ecdy below the
drain hole in the frame as shown in Figure 29
1. Oil drain valve
2, Machine frame
3, Oil drain hose
G0070B7
Figure 29
4. Pan
5, Oil filter
8. Turn the drain valve 1/4 counter
clockwise to open
and allow the oil to drain (Figure 29) Reanove the
oil fir cap/dipstick (Figure 27),.
9 Be sure to allow ample time for complete drainage.
10. Remove the old filter and wipe off the mounting pad
(Figure 29)..
1I. When oil has drained completely, dose the oil drain
valve. Remove the oil drain hose and wipe up any
excess oil on the frame (Figure 29)..
12.
15.
Note:
Dispose of the used oil at a recycling center,
Place the new replacement filter in a shallow pan
with the open end up, Pour new oi! of the proper
t3rpe, in through the threaded center hole.. Stop
pouring when the oil reaches the bottom of the
threads.. Allow a minute or two for the oil to be
absorbed by the filter material
Apply a thin film of clean oil to the rubber gasket on
the new filter°
14. Install the replacement
oil filter to the mounting pad,
Turn the oil filter clockwise until the rubber gasket
contacts the pad, then tighten the filter an additional
2/.3 to 1 turn (Figure 30).
28