Operation - Central Machinery 44846 Assembly And Operating Instructions Manual

a wrench.
- Rotate the Table until it is square to the bit.
- Retighten the Hex Bolt (B12).
Warning: avoid personal injuries. before operating this machine, review all safety Warn-
ings and precautions listed on pages 2 through 5.
drilling
While following these procedures, refer to the photo on page 5.
1. Loosen the Table Clamp (B13) and turn Crank (B8) to adjust the Table height to
accommodate the workpiece being drilled. Retighten Table Clamp.
2. Open the Chuck (A12) and insert the drill bit in the center. Tighten with the Chuck Key.
3. Secure the workpiece (and backup material) to the Table using a vise and/or clamp.
The workpiece sits on the backup material which in typically a scrap piece of wood
used to stabilize the workpiece. It also helps the drill make a cleaner hole. To keep it
from spinning, have it touching the left side of the Column.
4. Bring the drill bit down with the Feed Knob (34) to where the hole is to be drilled.
Make minor workpiece alignment adjustments.
5. Plug the Power Cord (29) into an electrical outlet.
Warning: Wear an ansi approved, full face shield while drilling any type of material.
6. Push the Switch (2) up to turn the Motor ON.
7. Pull down on the Feed Knob and slowly drill the hole into the workpiece.
Warning: if the drill bit grabs and spins the workpiece, do not attempt to stop the spin-
ning with your hands. step back, and push the switch down to the off position. Wait
for the spindle to stop turning before dislodging the workpiece.
8. When the drilling is complete, press the Switch to the OFF position.
adjusting the head angle
caution: before making any adjustments, unplug the power cord (29) from the electri-
cal outlet.
1. To adjust the Head angle to other than 90 degrees, loosen the right Clamping Lever
(B30).
2. Pull out the Guide Pin (16) and turn it 90 degrees so that it's cross pin rests on top of
the outlet.
3. Align the mark on the Column Guide (18) with the Scale (33).
4. Once the Head is tilted to the desired angle, retighten the Clamping Lever.
SKU 44846

operation

Page 7