Central Machinery 44846 Assembly And Operating Instructions Manual page 4

replacement parts. Use of any other parts will void the warranty. Only use accessories
intended for use with this tool. Approved accessories are available from Harbor Freight
Tools.
19. do not operate tool if under the influence of alcohol or drugs. Read warning
labels on prescriptions to determine if your judgment or reflexes are impaired while
taking drugs. If there is any doubt, do not operate the tool.
20. use proper size and type extension cord. If an extension cord is required, it must
be of the proper size and type to supply the correct current to the tool without heating
up. Otherwise, the extension cord could melt and catch fire, or cause electrical
damage to the tool. This tool requires use of an extension cord of 0 to 12 amps
capability (up to 50 feet), with wire size rated at 16 aWg. Longer extension cords
require larger size wire (smaller AWG number). If you are using the tool outdoors, use
an extension cord rated for outdoor use. (Signified by "WA" on the jacket).
21. secure Workpiece. Use clamps or a vise to hold workpiece, if possible. Never hold
workpiece with your hands.
22. never leave drill press running unattended. Turn the power OFF.
23. Maintenance. For your safety, service and maintenance should be performed
regularly by a qualified technician.
note: Performance of this tool may vary depending on variations in local line voltage. Exten-
sion cord usage may also affect tool performance.
Warning: the warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. it must be under-
stood by the operator that common sense and caution are factors which cannot be built
into this product, but must be supplied by the operator.
drill press safety Warnings and precautions
1. Secure the Drill Press Base to the floor using 7/16 inch bolts (not supplied).
2. Locate the Drill Press in an area where you walk around it unhampered.
3. Avoid kickback and grabbing by clamping the workpiece to the table, or use a vise that
is secured to the table. If the workpiece begins to spin, do not attempt to stop it with
your hands. Turn the motor OFF, and wait until it stops spinning before attempting to
remove it.
4. Avoid being caught and pulled into the spinning chuck. Do not wear gloves, long
sleeve shirts, ties, or jewelry. Long hair must be bundled behind the head.
5. Never place hands and arms near the workpiece to avoid the possibility of the
workpiece coming loose and striking you.
6. Before drilling, turn on the motor and check for bit wobble or machine vibration. If this
is found, correct the problem before drilling.
7. Set the proper spindle speed for the specific drilling operation.
SKU 44846 Page 4