Out Of Balance Recovery Routine; Machine Information; Specifications - Fisher & Paykel excellence GW512 Installation Instructions And User Manual

Changing Pre-set Options
Out-of-Balance Recovery Routine
When your Smart Drive® is spinning it can sense if the
wash load is out-of-balance and will stop and re-try
spinning up to 3 times. If it still senses an unbalanced
load there are two options the machine can take.
Automatic Recovery Option
Your Smart Drive® will try to automatically correct the
out-of-balance load. It will fill with water and agitate to
redistribute the load before trying to spin up again.
Machine Stops Option
Your Smart Drive® will stop, give a short burst of beeps
every 5 seconds, and the RINSE or SPIN light will flash.
You must redistribute the load more evenly yourself.
(Use this option if you wish to conserve water).

Machine Information

Specifications

Model Capacity
GW712
GW612
GW512
MW612
MW512
Electrical Supply: 220 – 240V, 50Hz Sinusoidal, 165W
Inlet Water Pressure: Max. 1MPa (150 psi) Min. 34Pa (5 psi)
Inlet Water Flow Rate: Min. 3litres/min
Standpipe Height: 850 – 1200mm
Note:
Exact height of your Smart Drive® is dependent on how far the feet are inserted onto the base
of the machine.
*Height is measured to the highest point on the console.
28
Depth
7.5kg 650mm
6.5kg 600mm
5.5kg 560mm
6.5kg 600mm
5.5kg 560mm
Width Height*
650mm 1020 – 1050mm
600mm 1020 – 1050mm
560mm 1020 – 1050mm
600mm 1020 – 1050mm
560mm 1020 – 1050mm
REGULAR
light on = automatic recovery
REGULAR
light off =machine stops
Height (Lid Open)
1410 – 1440mm
1360 – 1390mm
1320 – 1350mm
1360 – 1390mm
1320 – 1350mm