Table of Contents
Advertisement
3,
Plug the power cord into the correct branch circuit receptacle. (Refer to
Voltage and Circuit Protection paragraph in the Installation section of this
manual.)
4.
Open the drain valve fully (counter-clockwise)
to permit air to escape and
prevent air pressure build up in the air tank during the break-in period.
5.
Move the On/Auto/Off
lever to "ON/AUTO"
position. The compressor
will
start.
6.
Run the compressor for 20 minutes. Make sure the drain valve is open and
there is minimal air pressure build-up in tank.
7.
After 20 minutes, close the drain valve (clockwise). The air receiver will fill
to "cut-out"
pressure and the motor will stop.
The compressor
is now ready for use.
Before
Each Start-Up:
1.
Place On/Auto/Off
lever to "OFF".
2.
Pull regulator knob out, turn counter-clockwise
until it stops. Push knob in
to lock in place.
3.
Attach hose and accessories.
NOTE: The hose or accessory will require a
quick connect plug if the air outlet is equipped with a quick connect
socket.
Too much air pressure causes a hazardous risk
of bursting. Check the manufacturer's
maximum
pressure rating for air tools and accessories.
The
regulator outlet pressure must never exceed the maximum
pressure rating.
How to Start:
1.
Turn the On/Auto/Off
lever to "AUTO" and allow tank pressure to build.
Motor will stop when tank pressure reaches "out-out"
pressure.
2.
Pull the regulator knob out and turn clockwise to increase pressure. When
the desired pressure is reached push knob in to lock in place. The
compressor
is ready for use.
NOTE: Always operate the air compressor
in well-ventilated areas free of
gasoline or other combustible
vapors. If the compressor
is being used to
operate a sprayer DO NOT place near the spray area.
D24064
14- ENG
Advertisement
Table of Contents
