Table of Contents
Advertisement
Dipstick: Indicates the amount of oil in the pump, the +
mark indicates
full and the - mark indicates oil needs to
be added. See Oil paragraphs in the Maintenance section
for instructions.
Motor Thermal Overload Protector (not shown): This
motor has a manual thermal overload protector. If the
motor overheats for any reason, the overload protector
will shut off the motor, The motor must be allowed to
cool down before restarting.
To restart see the "Motor"
paragraph in the "Maintenance"
section.
Air Intake Filter:. This filter is designed to clean air
coming into the pump. This filter must always be clean
and ventilation openings free from obstructions. See
"Maintenance".
Check Valve: When the air compressor
is operating,
the check valve is "open", allowing compressed air to
enter the air tank. When the air compressor reaches
"cut-out" pressure, the check valve "closes", allowing air
pressure to remain inside the air tank.
Pressure Release Valve: The pressure release valve
located on the side of the pressure switch, is designed
to automatically release compressed air from the
compressor head and the outlet tube when the air
compressor reaches "cut-out"
pressure or is shut off.
The pressure release valve allows the motor to restart
freely. When the motor stops running, air will be heard
escaping from this valve for a few seconds. No air
should be heard leaking when the motor is running, or continuous leaking after
unit reaches "cut-out"
pressure.
How to Use Your Unit
How to Stop:
1.
Set the On/Auto/Off
lever to "OFF".
Before
Starting
Break-in Procedure
_
Serious damage may result if the following
break-in instructions are not closely followed.
This procedure
is required before the air compressor is put into service and
when the check valve or a complete compressor pump has been replaced.
1.
Make sure the On/Auto/Off lever is in the "OFF" position.
2.
Check oil level in pump. See "Oil" paragraph in the "Maintenance"
section
for instructions.
NOTE: Pull coupler back until it clicks to prevent air from escaping through the
quick connect.
13-ENG
D24064
Advertisement
Table of Contents
