Fisher & Paykel HS60CSRM1 Installation Instructions And User Manual page 7

Mounting to cabinetry sides
Fix rangehood to your wall units, with 2 screws in each side into the vertical panels. To do this:
Slide out the drawer and remove filter. You will see two mounting holes running through the
1
moulded sides (see Fig.7).
Remove the thin plastic skin (A) from each side fixing hole. An 8 mm diameter drill bit is
2
recommended.
Position slideout (ensuring unit is level) and fix in place using screws and hollow dowels through
3
each side fixing hole (see Fig.8). (Check screw length with thickness of cabinet panels).
The rangehood's plug can be easily plugged into the nearest wall socket, or if connected directly
into the house wiring, a registered electrician is required.
Installation instructions
Fig.7 Fixing holes
Cupboard
Fig.8 Side mounting
Hollow Dowel
Slideout Slide
5