Entering Remote Control Codes - Onkyo HT-R990 Instruction Manual

Onkyo components that are connected via 941 are
controlled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
1 Make sure the Onkyo component is connected with
an 94 1 cable and an analog audio cable (RCA).
See "Connecting Onkyo 1-41 Components" for details
(O page 19).
2
Enter the appropriate remote control code for
REMOTE MODE, referring to the previous
section.
42157:
Onkyo cassette tape deck with 94 I
81993:
Onkyo Dock with 1-41
3 Press REMOTE MODE, point the remote
controller at the AV receiver, and operate the
component.
Controlling Onkyo components without 94 !
If you want to control an Onkyo component by pointing
the remote controller directly at it, or you want to control
an Onkyo component that's not connected via 94 I, use the
following remote control codes:
30627:
Onkyo DVD player without 941
71817:
Onkyo CD player without 94 I
32900/33100/33500:
Onkyo Blu-ray Disc player
32901/33104/33504:
Onkyo HD DVD player
70868:
Onkyo MD recorder without 94 I
71323:
Onkyo CD recorder without 94 I
82990:
Onkyo Dock without 941
You can reset the remote controller to its default settings.
1
While holding down RECEIVER, press and hold
down HOME until the remote indicator lights
(about 3 seconds).
2 Within 30 seconds, press RECEIVER again.
The remote indicator flashes twice, indicating that the
remote controller has been reset.
By pressing the REMOTE MODE that's been
programmed with the remote control code for your
component, yon can control your component as described
below.
For details on entering a remote control code for other
components, see "Entering Remote Control Codes"
(o page 64).
Controlling a TV
TV
is preprogrammed with the remote control code for
controlling a TV that supports the 1-411-1D'1 (limited to
some models). The TV must be able to receive remote
control commands via I-'4II-ID and be connected to the
AV receiver via HDMI. If controlling your TV via
I-'4II-ID doesn't work very well, program your TV's
remote control code into TV and use the TV remote mode
to control your TV.
Use the following remote control codes:
} 11807/13100/13500:
TV with 1-41HD
Controlling a Blu-ray Disc/DVD Player, HD
DVD Player or DVD Recorder
BDIDVD
is preprogrammed with the remote control code
for controlling a component that supports the F4.]I-II_*l
(limited to some models). The component must be able to
receive remote control commands via F4.II-IID and be
connected to the AV receiver via HDMI.
Use the following remote control codes:
32910/33101/33501/31612:
Blu-ray Disc/DVD player with F4.II-IID
You can reset a REMOTE MODE to its default remote
control code.
"1
The r-qn-ID supported by the AV receiver is the CEC
system control function of the HDMI standard.
2
While holding down REMOTE MODE that you
want to reset, press and hold down HOME until the
remote indicator lights (about 3 seconds).
Within 30 seconds, press REMOTE MODE again.
The remote indicator flashes twice, indicating that the
button has been reset.
Each of REMOTE MODE is preprogrammed with a
remote control code. When a button is reset, its
preprogrammed code is restored.
En
65