NordicTrack SUMMIT 4500 NTTL16902 User Manual page 7

4. SlidetheGrounding B racket ( 107)ontooneofthe
Handrail Spacers (65)inthelocation shown.
Seeinsetdrawing A. Pinch thetabsontheGrounding
Bracket (107)sothatthetabswillfitintotheholeinthe
Upright (69)(seeinsetdrawing B).
Seeinsetdrawing B.Place the Handrail Spacer ( 65)on
theleftUpright (69)asshown, w iththecutout o ntheindi-
catedside.Note: M akesurethatthetabsonthe
Grounding B racket ( 107)(seeinsetdrawing B)arein-
sertedintotheholeinthe Upright.
5. Pull t he Upright WireHarness (98)upthrough theother
Handrail Spacer ( 65).PlacetheHandrail Spacer o nthe
rightUpright ( 69)asshown, w iththecutout o ntheindi-
catedside(seeinsetdrawing A).
Have a second person holdtheHandrails ( 66)nearthe
Uprights ( 69)asshown. C onnect the Upright Wire
Harness ( 98)tothewiresextending f romtheConsole
Base(81).Insert t heconnectors a ndtheUpright Wire
Harness i ntotheholeintheConsole Base(seeinset
drawing B).
SettheHandrails ( 66)ontheSpacers ( 65),beingcareful
nottopinchtheUpright WireHarness (98).
Z
}<
A
Tabs
107
A
81
81
6. Insert two Handrail Bolts (78) with Handrail Washers
(77) and Handrail Bushings (75) into the right Upright
(69) and the right Handrail Spacer (65). Turn the
Handrail Bushings so they fit against the Upright with the
thick sides of the Bushings toward the center of the
treadmill as shown in the inset drawing. Lift the right
Handrail (66) slightly and align the Bolts with the holes in
the Handrail. Next, thread the Bolts into the Handrail. Do
not tighten the Bolts yet.
Attach the left Handrail (not shown) in the same way.
Tighten all four Handrail Bolts (78).
75
77 78
Thick
Side
7. Make sure that all parts are tightened before you use the treadmill. Note: If there is a thin sheet of clear
plastic on the face of the hood decal and the "ComforTrack" decal, remove it. Keep the included allen wrench in
a secure place. The allen wrench is used to adjust the walking belt (see page 27). To protect the floor or car-
pet from damage, place a mat under the treadmill.