NordicTrack CX 1050 NEL12940 User Manual page 6

2. Identify the Pivot A xle(14),whichis thelongerofthe
twoaxles. S lidea RampCover(48)ontoanM6x
16mmPatch Screw(76)as shown. T ighten the Patch
Screwintooneendof the Pivot A xle.Applya small
amount o f theincluded g rease tothe Pivot A xle.
Havea second person holdthetwoRampSpacers
(99)against t hesidesofthe Frame (1)so theycover
theindicated tubesontheFrame. L iftthePedal L egs
(notshown) outofthewayandaligntheround tubes
onthe Ramp (3)withthe Ramp Spacers. M akesure
that the Ramp is turned as shown in drawing 3
below. Insert the Pivot Axle (14) into the Ramp, the
Ramp Spacers, and the Frame. If necessary, tap the
Pivot Axle with a rubber mallet to insert it.
Slide the other Ramp Cover (48) onto an M6 x 16mm
Patch Screw (76) as shown. Tighten the Patch Screw
into the other end of the Pivot Axle (14).
3. Slide an M6 Washer (64) onto an M6 x 16mm Patch
Screw (76). Tighten the Patch Screw into one end of
the Incline Axle (13). Apply a small amount of grease
to the Incline Axle.
Raise the Ramp (3). Insert the Incline Axle (13) into
the welded tube under one side of the Ramp, through
the motor screw, and then into the welded tube under
the other side of the Ramp. As you insert the Incline
Axle through the motor screw, make sure that the
motor screw does not turn.
Slide an M6 Washer (64) onto an M6 x 16mm Patch
Screw (76). Tighten the Patch Screw into the open
end of the Incline Axle (13).
4. Have another person hold the Upright (2) in the posi-
tion shown. Make sure that the Upright is turned as
shown in drawing 5 on page 7.
Connect the Upper Wire Harness (115) to the Lower
Wire Harness (42). Carefully pull the upper end of
the Upper Wire Harness to remove the slack from
the Wire Harnesses. Insert the Upright (2) into the
Frame (1). Be careful to avoid disconnecting or
pinching the Wire Harnesses. Attach the Upright with
two M10 x 108mm Button Screws (70), two M10 Split
Washers (73), and two 7.6mm Spacers (109). Make
sure that the curved sides of the Spacers are fac-
ing the Upright. Be careful to avoid damaging the
Wire Harnesses with the Button Screws. Do not
tighten the Button Screws yet.
Grease
48
14
76
48
99 Tubes
1
Motor
Screw
G_ase
13
64
70_
1
1
109
6