Philips VRKD12BL Instruction Book page 11

Hide thumbs Also See for VRKD12BL:
Table of Contents

Advertisement

• Before turning on yourVCR, make sure there are batteries in
the remote control and the VCR and TV are connected (see
pagesfive and seven-10).
• You can not set up channels if you are using a Cable Box/DBS.
• The instructions on this page only work when you turn on the
VCR for the first time. If there is a power failure or if theVCR is
unplugged for more than one minute, you may need to repeat
the instructions on this page.
I
Press the POWER button. The POWER light and the VCR/TV
light will appear on the front of theVCR.
2
Turn on the TV. Set it to the same channel as the
CH3_I_H4 switch on the back of theVCR. The display shown
below witl appear on the"iV.
LANGUAGE
SELECT
I_"ENGLISH
[ON]
ESPA/_OL
3
Press the PLAY button or the STOP button to select
ENGLISH
or ESPAI_IOL. [ON] will appear beside your choice.
4
Press the F.FWD button or the MENU button. AUTO SET
UP will appear on the screen.
_
AUTOSETUP
_
5
Press the MENU button, the F.FWD button, or the
REW(ind)
button to begin automatic channel setup. AUTO
SET UP will flash on the screen and channel numbers will appear
in the top right corner of the screen.When channels are set up,
the TV will go to the lowest channel available.
The VCR will memorize all availablechancels, so when you use the
CHANNEL _/_
button, you'll only scan through channels that
you receive.
Turn on the TV. Set it to
channel 3 or 4.
I
PHILIPS
_ful
Hints
,
If you do not see any messageswhen
you turn on the VCR,check your
hookups, then try again. If you still do
not see any messages,follow the
steps under "Automatic TV Channel
Setup'on page 12 and "Choosing a
Language"on page 16.
If you try to set up channels when
there is no antenna or cable connect-
ed to the VCR,channel setup will
appear to take place. Eventually,
AUTO SET UP will appear on the
screen steadily,and channel setup will
stop.Connect an antenna or cable to
the ANT(enna) IN jack of the VCR,
then press the MENU button, the
EFWD button, or the REW(ind) but-
ton again. Channel setup will begin
again.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vkrd11yl

Table of Contents