Magnavox ZV457MG9 Owner's Manual page 34

You can easily switch the analog TV (NTSC) and digital TV
(ATSC) with the remote control.
Press [DTV/TV] on the remote control.
• The analog mode and digital mode switch alternately.
Select channels by using [CHANNEL -_-/--] or [the
Number buttons] found on remote control.
[CHANNEL Jr / --]
Use [CHANNEL Jr/--] to change the channel.
[the Number buttons]
Press the channel number with [the Number buttons] to
select a channel you want to watch.
<Analog TV Channels>
Enter the channel number with [the Number buttons] to
select a channel you want to watch.
For 1-digit number
e.g.) 2 ch: [0] + [2], [2] + [.] or
[2] + leave it for 2 seconds.
For 2-digit number
e.g.) 12ch: [1] + [2]
<Digital TV Channels>
Enter the major and minor channel number with [the
Number buttons] to select a channel you want to watch.
For 1-digit number
e.g.) 2-2 ch:
major channel [0] + [2] or [2] + [.]
minor channel [0] + [2], [2] + [.] or
[2] + leave it for 2 seconds.
For 2-digit number
e.g.) 35-16ch:
major channel [3] + [5]
minor channel [1] + [6]
• If you enter 1 digit for major channel and leave it for 2
seconds, the number will be taken as the major channel
and lowest minor channel of the major channel will be
displayed.
• If there is no minor channel input, lowest minor channel
of the major channel will be displayed.
iinininii
@
inininin
About digital TV broadcasting:
iin_iliii_Jiiiiiiiiiiii
ininininininininininininininininininii linininii
With its high definition broadcast, digital broadcasting far
surpasses analog broadcasting in both its picture and
sound quality.
What is the minor channel?
By using high compression technology, digital
broadcasting offers a service that enables multiple signals
to send simultaneously.
Therefore, you can select more than one program per
major channel since digital broadcasting technology
distinguishes between multiple channels broadcast by a
single network.
NTSC (analog mode) [AirTime] ATSC (digital mode)
18:00
18:30
19:00
19:30
20:00
IT l___
I
major channel minor channel
,_ : change automatically
_> : change manually by using [CHANNEL-t-/--]
32 EN