Magnavox VR9720AT01 Operating Instructions Manual page 30

CONNI=CTIONS TO MAKE BEFORE RECORDING (Cq
CABLE CONNECTIONS
[2]
IBASlC C,.,E CONNECTION ]
WITH A (CABLE TO VCR) CONVERTER/DESCRAMBLER BOX
If your cable service supplies you with a converter box, you can use the basic connection shown here. If your
cable system is different, refer to "ALTERNATE CABLE CONNECTIONS" on the following pages.
Cable TV
Converter Box
Back of TV
TV Anteh_- _1.
I
Panel
I
I
I
I
I
I
I/
(cable)
Input
With this connection, you can record and view any channel including scrambled channels. However, channel
selection must be made at the cable company converter box. Therefore, the VOR's remote channel control feature
cannot be used, unattended recording is limited to one channel at a time, and you cannot view another channel
other than the one you are recording.
TO RECORD AND VIEW A SCRAMBLED/UNSCRAMBLED CHANNEL
1, Set the VCR/TV selector located on the front of VCR to "VCR".
2. Set TV channel selector to the output channel of the VCR
3. Set VCR channel selector to the output channel of the Cable Converter Box. (e.g. CH 3).
4. Select channel to be recorded at the Cable Converter Box.
TO WATCH "rv (WITH THE VCR OFF)
1. Set TV channel selector to the output channel of the Cable Converter Box.
2. Select the desired channel on cable converter channel selector.
Note to CATV system installer:
This reminder is provided to call the CATV system installer's attention to Article 820-22 of the NEC in USA
(and to the Canadian Electrical code in Canada) that provides guidelines for proper grounding and, in particular,
specifies that the cable ground shall be connected to the grounding system of the building, as c!ose to the
point of cable entry as practica.