Advertisement
our IV remote can be set to
york your VCR or Cable
Converter
by what is caUed the
SEARCH method.
If the "REMOTE
CODE" number
method shown in the previous
section did not._et your remote to
work your VCR or Conw;rter,
then
follow
the easy steps listed below.
Please read through
steps 1-4
before
beginning.
_,,_
Press the
on
POWER
button
I he VCR or Converter
to turn the
unit ON.
_-)
Stand at least six feet away
from the front of the VCR or
Converter.
Point the remote
toward the unit.
HOLD
DOWN
the SURF and
the desired
System
(VCR or
CBL-Converter)
button, s at the
same time. KEEP HOLI-_ING
BUTTONS
DOWN.
_._
Watch the Channel Indicator
on the unit.
I Channel Numbers will SCAN UP
I when the unit has been identified.
This may take up to two minutes.
_._
Release the SURF and System
(VCR or CBL) buttons as soon
as channel numbers sta_: to scan
up. The code has been identified
and the remote is ready to operate
with the VCR or Conve_ter.
CABLE CONVERTER
Don't let :th¢ :_R. _o_:Conve ner
.... ,,, !!i!iiiiiiiiiiii iiiiiiiiiiiiiiii iiiiiiiiiiiiiiiiiiiiiiiii i ?
....
,
Six Feet
(minin'num)
1,
Remember, a minute or
two can seem ver3, long, but
the code should be located within
two minutes.
Don't let the VCR or Converter
scan up more than five channels.
The remote may pass up the right
code and another two minute
search cycle will have to be
repeated.
If no channel change happens
within two minutes,
repeat steps 1-
4. Should a channel change still
not occur, the remote will not
work with the desired u_ait.
44
Advertisement
