Advertisement
th the use of an optional
Dolby
urround Prologic
Amplifier
you
can receive the added sound
dimension found only in Dolby
Surround
programs.
Dolby
Surround
combines
wide left-to-right
stereo
separation
_rith solid center channel
imaging,
complemented
by a front-to-
back soundfield
effect. The result for
you the listener is to create a movie
theater or concert hall "you are there"
sound sensation.
_
Connect
the FIXED
Audio
Output
jacks on the TV to the AUX
INPUT jack,,; on a Dolby Prologic
Audio Amplifier system.
_z2._
Connect
the CENTER
CHANNEL
Input jack
on the TV to
the CENTER
PRE-AMP jack on the
Dolby Prologic Amplifier.
_
Connect
the rear set of Surround
Sound
speakers
to the (+,-)
connections
on the Dolby Surround
Amplifier.
Place the Audio System's
Front and
Rear Surround
speakers
as shown in
the picture on this page.
.-_ Turn the "IV ON. Set TV Volume
to
normal listening
level. Place the TV's
TV SPEAKERS
(Sound
Menu 2 of 3)
control to "(.'ENTER
CHANNEL
INPUT".
Turn the Dolby Prologic
Amplifier
ON. Place its SURROUND
MODE
control
to the Dolby Prologic
mode.
_
The full effect of DOLBY
SURROUND
programs
(either
broadcast,
VCR, or VDP) can now be
heard throu,;b the TV and Amplifier
system speakers.
Remember.
R(ight)/L(eft)
channel
stereo sound and rear
Surround
sound Will be heard from the
external (or Dolby Prologic
Amplifier
system) speakers.
The TV's front
cabinet speakers
are used for true
Center Channel sound necessary
to
complete
the Dolby Prologic
Surround
arrangemeELt.
You will need the following to set-up and use the designed
SURROUND
SOUND system shown below:
One set of rear Surround Sound speakers
One Dolby Prologic Audio Amplifier (with Center Pre-Amp
Output and twin speakers)
One DOLBY SURROUND
encoded source (either playback -
VCR,, VDP, etc.- or broadcast).
AUDIO
Dolby Prologic
Left Front
Right Front
Speaker
I ('ENTER
CHANNEL
IN
_,
jack's volum,_, bass,
and treble[
level.,i can ba adjusted
with the I
TV's VOLAV
buttons
or using
I
the omscreen
Menu controls.
,_
__
•
L
R, L REAR
SURROUND
SPEAKERS
R SPEAKER
OUTPUT
lO:_ot.oc_
>
Audio
CENTER
CHANNEL
PRE
AMP
OUT
Amplifier
LEFT
SPEAKER
OH/NN_
L
AUDIO
OUTPUT
INPI
CENTER CHANNE;L
Use the noise sequencer (or scund test signal) on
the Dolby Prologic Amplifier. Adjust the Center
Channel volume level (using the Dolby Prologic
Amp's Center Channel Volurr e control) to equal
the left!right and surround speaker volume levels.
If Center Channel volume is s ill too low after
using the Dolby Prologic Amplifier, use the TV's
Volume control buttons to set desired Center
Channel level.
Make sure the TV's BALANCE control is set to
the middle podtion or the Center channel sound
image will no: be centered.
Use the Dolby Prologic Amp] fier's Volume
buttons to adjust the surround system sound level.
VIEWING AFIEA
REAR SURROUND
SOUND ,_iPEAKERS
I
RIGHT SPEAKER
29
Advertisement
