Fault Codes - Fisher & Paykel DishDrawer DD60 Series User Manual

How to recognise a fault code
When a fault has occurred, the DishDrawer® will continuously beep every second.
The fault code will be displayed on the electronic display for models with LCD and on the wash
programme selector for models with no LCD.
Each fault code is shown in the following chart.
How to attend to a fault code
Press the button to remove the fault code.
1
If the fault code and continuous beeps cannot be removed by pressing the
2
DishDrawer® off at the power supply.
We recommend you check the following chart and correct the fault where possible.
3
After attending to the fault, turn the DishDrawer® on at the power supply.
4
If the fault code and continuous beeps remain, turn the water and power supply off to the
5
DishDrawer®.
When calling your Authorised Service Centre, advise them of the fault code that has appeared
6
on the DishDrawer®. This information will help the Authorised Service Centre respond to your
request.

Fault codes

button, turn the
29