Light Bulb - GE JKP90 Owner's Manual

GEAppliances.com
[A WARNING
[ CAUTION
Receo]:acle
on some mooelSi
RecepTacle Socket
_G9 Bulb
Gloss cover
(on some models)
SHOCK OR BURN HAZARD: Before replacing oven light bulb, disconnect the electrical
power to the oven at the main fuse or circuit breaker panel. Failure to do so may result
in electric shock or burn.
i BURN HAZARD: The glass cover and bulb should be removed when cool. Touching hot
glass with bare hands or a damp cloth can cause burns.
Oven Light Replacement
To remove:
[Z] Turn the glass cover counterclockwise 1/4
turn until the tubs of the glass cover clear
the grooves of the socket.Wearing latex
gloves may offer u better grip.
r_ using gloves or u dry cloth, remove the
bulb by pulling it straight out.
To replace:
%
r2]
Rece
Z
Use a new !20/130-volt halogen bulb, not
to exceed 50 watts. Replace the bulb with
the same type of bulb that was removed.
Your model will have one of the two types
shown on the left. To determine the
correct replacement bulb, check the bulb
terminals. Bulbswith 2 straight pin
terminals are G6.35bulbs. Bulbs with 2 r_
looped terminals ore 69 bulbs. (Do not
interchange.) Be sure the replacement r_
bulb is rated !20 volts or !30 volts (NOT!2
volts).
Using gloves or u dry cloth, remove the
bulb from its packaging. Do not touch the
bulb with bare fingers. Oil from skin will
damage the bulb and shorten its life.
gloves Or
Pushthe bulb straight into the receptacle
all the way.
Placethe tabs of the glass cover into the
grooves of the socket.Turn the glass cover
clockwise 1/4 turn.
For improved lighting insidethe oven,
clean the glass cover frequently using a
wet cloth. This should be done when the
oven is completely cool.
[] Reconnect electrical power to the oven.
ii(i k i [i
,,Bulb,,
Gloss cover
Lower Oven Light Bulb (onsomemodels)
To remove:
Turn the glass cover counterclockwise 1/4
turn until the tabs of the glass cover clear the
grooves of the socket. Removethe bulb.
To replace:
Put in a new 40-watt appliance bulb. Place the
tubs of the glass cover into the grooves of the
socket. Turn the glass cover clockwise !/4 turn.
NOTES:
A 40-watt appliance bulb issmaller than
a standard 40-watt household bulb.
Install and tighten the cover clockwise.
Reconnect electrical power to the oven.
For improved lighting inside the oven, clean
the glass cover frequently using a wet
cloth. This should be done when the oven is
completely cool.
37