Using Function Button - Panasonic TH-65VX300ER Operating Instructions Manual

Using FUNCTION button

Assigning functions to the FUNCTION button on the remote control enables a user to switch
between show/hide and modes with just a single touch of a button. The function settings are
con gured by using "Function Button Settings" in the Setup menu (see page 57). The button
functions are con gured in two ways depending on the setting (On/Off) of "Studio mode" in the
Options menu.
The factory preset functions are as described below.
Function Button 1: 3D Settings
Function Button 2: Signal
Function Button 3: Colour gamut
Function Button 4: Scrolling bar
Display of the FUNCTION button guide
Pressing the FUNCTION button can display the FUNCTION button guide to refer for the function
of each button.
Function
1: 3D Settings
If the guide display is not needed, set "Function Button Guide" in "Function Button Settings" to "Off" (see page 57).
3D Settings / Signal / Colour gamut
Scrolling bar / Test Patterns
Scrolling bar
Activates the "Scrolling bar only" screensaver. After
15 minutes, the display enters standby mode.
To exit this mode, press any button.
Note:
"PC Power management" and "No signal power off" are deactivated during "Scrolling bar" or "Test Patterns"
operation. (see page 43)
62
2: Signal 3: Colour gamut
The menu screen is displayed.
(Example: 3D Settings)
3D Settings
3D Function On
3D Picture Format Auto
3D Viewing Mode
3D
3D Picture Sequence Normal
3D Colour Compensation On
Safety Precautions
Pressing the FUNCTION button clears the menu.
Con rmation screen (Example: Scrolling bar)
Function
Scrolling bar
Yes No
The operation starts.
4: Scrolling bar
Press to select
The operation starts.
"Yes".
Press.
Test Patterns
Each time you press , a different test pattern is displayed
(seven in all).
Colour Bars
Black 1% window
To exit this mode, press any button other than
Red Green
Frame
(2 lines × 2 dots) Blue
.