3D Settings - Panasonic TH-65VX300ER Operating Instructions Manual

3D Settings

To view the 3D images, please adjust and setup the 3D settings.
Note:
Set these settings for each input terminals.
3D Settings
Signal
Waveform Monitor
Marker settings
RGB/MONO settings
Screensaver
Extended life settings
Input label
Function Button Settings
On/Off Timer Setup
Day/Time Setup
Network Setup
Component/RGB-in select
RGB
• 3D Function
On OFF
On: To view the 3D images, please set it to "On". You can see 3D images for 3D image signal and 2D images for
2D image signal.
Off: You can see 2D images instead of 3D images.
When set to "On", "3D" is displayed during 3D images.
• 3D Picture Format
3D images method is set.
Auto: 3D images are automatically displayed according to the signal.
Simultaneous: Set this format when selecting a slot that one of the following terminal boards is installed:
Dual HD-SDI Terminal Board for 3D (TY-FB30DHD3D), Dual DVI-D Terminal Board for
3D (TY-FB30DD3D)
Side by Side/Top and Bottom: One of the formats of the 3D standard. Select these formats as necessary.
Native: Displays the input signal as it is. Use to identify the format type of the input signal.
• 3D Viewing Mode
The 3D images are separated and displayed as right and left images.
3D: Normal 3D images display (initial setting)
Comparison: Left image (L) and right image (R) are placed side by side. If the 3D system is "Top and Bottom", the
images are displayed, being set one above the other.
Left: Only the left image (L) is displayed.
Right: Only the right image (R) is displayed.
3D
Notes:
• This function is disabled during 2D images.
• The factory default setting is "3D". To view the 3D images, please use "3D".
• 3D Picture Sequence
Reverse Normal
This function calibrates the timing to switch the right and left images as well as the timing to switch the shutter of
right and left 3D Eyewear.
Select "Reverse" if you feel that the sense of depth is unusual.
• 3D Colour Compensation
On Off
The colour adjustment during the 3D images is set.
On: The colour when using the 3D Eyewear is adjusted. (initial setting)
Off: The colour when using the 3D Eyewear is not adjusted. The 2D image setting is used.
Note: The factory default setting is "On". To view the 3D images, please set it to "On".
• Safety Precautions
Displays the precautions for viewing 3D images.
Select the item and set.
access
2
3D Settings
3D Function
3D Picture Format
select
1
3D Viewing Mode
3D Picture Sequence
3D Colour Compensation
Comparison
On
Auto
3D
Normal
On
Safety Precautions
PC
3D
16:9
NANODRIFT
Left
Setup menu
change
2
select
1
Right
45